View Single Post
  #2  
Old 11th October 2018, 12:06 PM
jps jps is offline
Senior Member
 
Join Date: May 2012
Location: Colchester, Essex
Posts: 439
Default

Quote:
Originally Posted by DaveyB View Post
Hi guys I was just wondering if any one could advise on when tightening these nuts should I add some loctite retainer . The nuts are of a nyloc type but just thought belt and braces approach.

Any thoughts would be greatly appreciated.

Thanks,

DaveyB.
I haven't seen mention of using threadlock - but Haynes says they have to be torqued to 300ft/lb or thereabouts - so I think they're fairly tightly in place anyway...

I've just refitted my rear hubs and driveshafts - will be interested to hear how you a) get the right torque in the hub nuts and b) get the right torque inthe CV joint bolts. I can't stop the hubs turning to tighten them properly!
Reply With Quote