View Single Post
  #18  
Old 10th January 2010, 08:34 PM
RAYLEE29's Avatar
RAYLEE29 RAYLEE29 is offline
Senior Member
 
Join Date: Sep 2008
Location: POOLE DORSET
Posts: 520
Default

I used the 19mm Axminster one set up in the pillar drill and kept cutting and checking till i was happy with the fit basiclly full nut and washer of thread sticking out the top and the largest bit of the taper just visible below the upright.
The taper is a good enough fit that after only tightening a little the need to be tapped to get back off.
Ray
__________________
Total spend so far £1116.08
1ST ALBUM HERE
2ND ALBUM HERE
Reply With Quote