Thread: Steveh1's build
View Single Post
  #56  
Old 6th December 2015, 12:05 AM
SteveH1 SteveH1 is offline
Senior Member
 
Join Date: Jun 2015
Location: Dublin Ireland
Posts: 291
Default

I got a few hours this afternoon in the shed.
So i started on the rear panel rails and it was something i wasn't particularly looking forward to as i didnt know anyone with the capability of bending the tubes so i had to notch the tubes to get them to bend
I was also worried about trying to get the two of them to match
So i welded the two tubes together temporarily cut the notches and bent the tubes together
This worked quiet well it also ensured that the two bends were perpendicular

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr
Not the nicest to look at

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
Reply With Quote