I'm a bit lost with this now. I've got a set of zx6r carbs with tps, the wiring loom from the bike, and a fuel pump. I'm a bit stuck with how to make the manifold as my cvh head has the coolant coming out just behind the 4th cylinder in a sort of large square shaped hole. I'm guessing I need to make a pipe outlet of some kind on the manifold i make and then re-route the coolant out of this pipe into the donor thermostat housing somehow?? There's also a lot of electrical connections on the top & bottom of the donor manifold so do I need any these and if so where do I move them to? Starting to wonder if I've bitten off a bit more than I can chew with this one and maybe should have stuck with chopping up the chassis to make the donor fit as is
