I bought the EDS saver pack and it doesn't fit. Spoke to EDS and it would appear these are for Cortina and Capri uprights. The TRE taper is way too small for the taper hole in my diesel Sierra uprights. The drag link doesn't go all the way through the 3GE mushrooms to allow a full nut on. I can't ream them out either because the rubber is already up against the top of the mushroom. It might work if I get the mushrooms turned down a bit more but non access to a lathe was the reason I bought them in the first place.
It never rains but it bloody pours.
__________________
Total cost so far
Materials £3,150
Tools £855
|