Quick update from me, I've put the engine and gearbox back in the car for the time being as I got annoyed at tripping over the engine. My aluminium inlet manifold arrived from FastDan over at locostbuilders, my ZX6R carbs are also here so they have been bolted up to the head, I ordered some starrett hole saws last week which arrived early this week so I can cut out the hole for the sausage airfilter backing plate.
I've been making good progress on the pedal box which is nearly finished now, just need to finish the pedals and drill the holes for the master cylinder then fully weld.
I've also completed my roll bar which was quite a satisfying job to do.
I've recently been ordering a lot of parts ready for finishing exams at the end of May so I can get a good 6 weeks worth of work done on the car, brake pads arrived yesterday, which upon fitting I found out one of my calipers is seized, quick phone to my local motorfactors revealed they have a reconditioned pair in stock that they wanting rid of so are happy to sell them to me for £25 each, which seems like a good deal as they are £40 on ebay (£15 if you return your current set and then postage on top of that).
My clutch cable arrived today and I think my headlights (from SVC) and front indicators were attempted to be delivered earlier so I should get them tomorrow, my handbrake cable should hopefully arrive tomorrow as well.
Finally I've ordered a loom from Premier Looms for £160, which will be arriving in 2-3 weeks, I was originally planning on making my own loom, but thought life is too short and I don't really enjoy electrics so thought I should make my life a bit simpler and buy one off the shelf and hopefully get my car on the road sooner.
Next on the list is some more steel so I can make mounts for the passenger seat and some aluminium strip to secure the fuel tank + run some strip down to transmission tunnel for the loom, brake lines and fuel lines.
Then I'll be measuring up and ordering the propshaft, and brake and fuel lines. and putting then painting the chassis + putting the floor in.
|