Few bits arrived from Phil during the week - He is sending bits through as they're ready:
Got a coat of anti rust primer on the drums:
Followed by the first top coat:
Then I started looking at the manifold I need to make for the bike carbs:
Not sure if I should re-space the carbs or just go with tubes at an angle - Any opinions?
The tubes in the pic are from some scrap I had lying around - They match the ID of the carb outlet perfectly, but are thin so there is a bit of a gap between the silicone tube. Will this be ok (or even helpful in getting the angles to work) or do I need some thicker tube?