Quote:
Originally Posted by jasongray5
So on your side pannels Andy, Did you follow the line of the front frame down, marking it onto the side pannel? then cut down that line?
Cheers Jas
|
In all honesty the drivers side panel was already cut down where it follows the vertical angle of the front frame, & some of the cut outs for the suspension brackets were also cut, tho i had to increase the cutouts to allow the up/down movement of the wishbones to allow the suspension movement.
I did cut the area around the steering rack gaitor & felt it was easier on the eye if that area was cut to allow the rack gaitor & front lower wishbone enough "clearance" in the panel in one cut....if that makes sense
If you look closely in the pics you can see some of the GRP that is part of the side panel that goes under the chassis & i think i might trim that down a bit too.
cheers
andy