Thread: A couple of Q's
View Single Post
  #1  
Old 29th December 2009, 09:35 PM
andyuk697 andyuk697 is offline
Senior Member
 
Join Date: Aug 2009
Location: Barnsley southyorkshire
Posts: 100
Default A couple of Q's

Hi guys hope everyones had a good xmas..

i had chance to spend a few hours in the garage today making a few plates and have got a few questions ...

CP10x2 the hole from one end is 31mm and the other end is 25mm when welded in place which way is up?

GM1 and GM2 where on TT2 and TT3 do they go?

also i wonderd why do some diagrams in the appendix section state how many plates are required of the same number CP7 x2 for eg but then some dont CP18 for eg, not a major problem but annoying when you have made all the plates from the appendix then come to fit them you are some short.

thanks Andy
Reply With Quote