View Single Post
Old 25th June 2009, 07:46 PM
HandyAndy's Avatar
HandyAndy HandyAndy is offline
Senior Member
Join Date: Jan 2009
Location: cleveland
Posts: 3,917

if you place U1 as said in the text in the book square to BR7 then slide the piece U1 along & under TR1 then the top front corner of U1 should be aligned with the outside edge of TR1, suggest you clamp it in place then do the same in opposite hand with U2 & TR2, clamp that as well then look at the diagram at bottom of page 38 you will see that you need to achieve 361mm between the bases of U1 & U2, that is what is most critical for these uprights ( as long as they have been cut to the correct length & angled correctly) as they give the mounting angles for the upper rear front suspension brackets.

one question..... do you have the "first edition" book or the revised edtion thats states it was re printed in 2008?
as this may be relevant.

Flat Pack Chassis Kits for sale, contact me at
Reply With Quote