Quote:
Originally Posted by Tatey
I've finally decided to start wiring up my car after putting it of for a few months, I've got the cable tie bases ready and now just need to buy a set of ratchet crimps.
However I am having really difficulties knowing where to start, I have a premier looms wiring loom which has been a great help as it's all there with instructions, and I know what I am doing when I get to say the front loom and attaching it to the lights, fan and horn etc, but its the middle section of the loom with the fuses/instrument cluster wires that I am getting overwelmed with.
I think a good start for me will be to fix the middle section of the loom in postion, which will then allow me to work out from there and do the simple part I know how to do to build my confidence, however I am unsure where I should put everything to fix it in place. Obviously the fuse boxes will mount to the bulkhead panel, but how do people go about routing the front loom + engine loom, do they put it through a grommet in the bulk head or just bring it through the tunnel again?
|
Fix all the components like fuse and relay boxes where you want them, along with any ECUs, and as said one circuit at a time.
Start with the ones furthest away from the fuse box and work back. Try to keep the closer circuits running along the now already existing cable runs as far as possible as that keeps the wiring neat which looks better for the IVA.
My personal preference for wiring through bulkheads is to use an in line connector with a jam nut through the bulkhead. It keeps it neat and makes removal much easier should you ever need to. They can be quite expensive for large numbers of pins though.
If you are using EFI then put the engine on a separate loom too so that you can bring the engine out near complete. Much easier than scrabbling around in the depths of a bay for a crank sensor plug you can't see.