View Single Post
  #18  
Old 11th May 2015, 01:33 PM
jps jps is offline
Senior Member
 
Join Date: May 2012
Location: Colchester, Essex
Posts: 439
Default

Quote:
Originally Posted by vince View Post
thanks guys

i was going to rivet the floor , as i have lots of rivets and an air riveter ,

thanks for the advice on the floor brace for the seat mounts, i have sourced some material for that as well , its some 100mmx25mm open box section , this will allow several fixing holes for the seat runners for fine adjustment if needed

BB

Not sure what 'open box section' is - but I have gone with 25mm x 3mm strips on which to mount the seat runners. Avoids putting any more height than is necessary into the seat base - plus means you don't need to put crush tubes in - which you would with box section.
Reply With Quote