View Single Post
Old 15th October 2009, 10:06 PM
HandyAndy's Avatar
HandyAndy HandyAndy is offline
Senior Member
Join Date: Jan 2009
Location: cleveland
Posts: 3,917

Nice one Ginge, looking good, the seat back is fun as you feel you need three pairs of hands all at the same time
i hope you don,t mind me asking but has the build table dropped slightly under the nose area of the chassis? as there seems to be a small gap between the table & the bottom rails at the front end , might be the camera angle too,
as for fully welding, its best to leave it until you have all the diagonals & the "RS" parts tacked into place, also make sure you alternate where you fully weld, go from side to side/front to back etc to minimise any heat distortion from fully welding
when you "think" its all fully welded i,ll bet you a pint you,ll find one you missed i know i did

nice progress, i bet the kids & Mrs are impressed.

Flat Pack Chassis Kits for sale, contact me at
Reply With Quote