So i was given this roll bar its a standard caterham 7 bar
Untitled by
stephen harborne, on Flickr
Untitled by
stephen harborne, on Flickr
Untitled by
stephen harborne, on Flickr
So my plan is to cut off the original mountings on the thick bar and put a flat bar plate on each end.
Then make a plate the same as cp3 and cp4 and mount them 50mm higher straight above cp3 and cp4 with nuts welded on the inside
Like build a box if this makes sense 50mm high
can anyone see a problem with this
Can i then weld 50mm box section between these boxes with the seat belt anchorage's welded into this bar