ahhh... this is probably going to mean I just make/buy new uprights. My mounting plate is fully vertical not at 45 degrees and I would rather not have 14" on the front and 15" on the rear, or 15" all round for that matter.
By moving that lower hole up 6mm (or there abouts) will I alter the suspension/handelling characteristics?......... Actually thinking about it the top dimensions of the upright are what matter for the rear suspension. Altering the lower hole position should only effect the camber, which can be dialled out with the top camber adjuster??????????
Any other issues I should be awear of before I spend more money/cut more metal?!
Cheers
Josh