View Single Post
  #504  
Old 11th June 2013, 12:06 PM
K4KEV's Avatar
K4KEV K4KEV is offline
Senior Member
 
Join Date: Feb 2010
Location: WINGATE CO DURHAM
Posts: 1,511
Default

been doing a bit on the trans tunnel.....yet another job which is a PIA, wish I had done it before putting on the side panels.
I have now riveted up the rear panel and the nearside trans tunnel, I have the other side marked out and ready to cut.....again I have been using double sided tape and it is working a treat, much better than messy sikaflex and no worries about whether using too much or too little#.....I will need to seal some areas but I think that is the case for everyone.



Reply With Quote