View Single Post
  #5  
Old 5th November 2012, 05:25 PM
gaz05 gaz05 is offline
Senior Member
 
Join Date: Jun 2010
Location: Hexham,Northumberland
Posts: 278
Default

The handbrake set up looks right to me . Make sure you have a bit of the outer cable showing on the engine side of the adjustable nut. Connect one side and pull the cable through and the measure and fit the nipple to the other side. You should then have enough adjustment to tighten it up.

My clutch cable is similar but I've twisted it so it's vertical and it lines up a bit better. I'm going to fit a wire holder to the engine mount.
__________________
Total cost so far
Materials £3,150
Tools £855
Reply With Quote