View Single Post
  #4  
Old 25th May 2017, 08:51 AM
TalonMotorFabrication TalonMotorFabrication is offline
Senior Member
 
Join Date: Jun 2011
Location: Southminster Essex
Posts: 260
Default

I should clarify that I drew the chassis in Sketchup using the tubes in the book which produced a very different shaped result to that on page 34. BR3+4 are not at a true 10 deg which puts BR1+2 out of place as a result, I've had flat pack builders tell me that their chassis are +/- 5mm out in overall length.
I've changed the drawings to read as outside corner to corner measurements which should be easier to do using a tape as intended rather than trying to read internals with a floating tape measure.
Sorry for any confusion caused.
__________________
Unofficially rated No.1 supplier of fabricated Haynes Roadster parts by the workshop rat population.

Direct email talonmotorfabrication@gmail.com
Reply With Quote