View Single Post
Old 23rd September 2009, 01:34 PM
Tatey's Avatar
Tatey Tatey is offline
Senior Member
Join Date: May 2009
Location: Leicester
Posts: 827

Just for an update: My gas valve arrived last week so i started practising welding and i got the hang of it quite quickly. So i then set to work tacking up the bottom chassis rails, once i'd done that i decided to flip it over to make sure it was wasnt. The 2 pieces with the massive angle on them were not the same, meaning it sat slightly over to the left hand side, i got all of that sorted and it is symmetrical now.

I've tack welded the front frame together now, after reading through chris's tutorial on it a few times i managed to get it all right first time

I've also started tack welding the uprights onto the bottom rails, its all starting to come together now
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9

My Build Blog: - Last Update: 31st October 2020

Total Spent so far: Stopped counting
Reply With Quote