View Single Post
  #111  
Old 3rd June 2012, 07:47 PM
Tatey's Avatar
Tatey Tatey is offline
Senior Member
 
Join Date: May 2009
Location: Leicester
Posts: 827
Default

Quick update before I go on holiday for 10 days.

My mate came round to help me the other day and we managed to get quite a lot done, the new gearbox mount is in now and it is safe to say the new mount is 100% better than the old one, the gearbox moves a couple of mm, compared to the mass amounts of movement in the old one.

I've put another bulkhead bracket underneath the handbrake bracket for my brake lines, I decided on this as I felt it was a neater solution.

Welds were ground down to allow for bodywork/aluminium panels to be fitted.

I finally got round to buying some more steel and I have nearly finished mounting my passenger seat. I just need to profile some spaces so that the runners sit flat against the seats then weld in the mounts. Once this is done then I just need to weld in a few tube ends and then flip the chassis, and fully weld the brackets that have been put on recently.

The chassis can then be primed and painted satin black ready for the floor to be fitted.

I also popped round to NTS yesterday and managed to pick up all of the bodywork for my car for 205 (Nose cone, scuttle, front cycle wings, rear arches, bonnet and a carbon aeroscreen), they are all seconds and require a small amount of work but should look good. As they are all different colours I will be wrapping them in vinyl and have ordered this in tomato red (65 for 6x1.5m of cast automotive vinyl inc VAT and delivery, which is enough vinyl to do the entire car) as well as some wing stays from ebay (I'm starting to get sick of fabrication and at 43 they were a bargain in my eyes), and finally I've ordered some body filler to fill in a few chips/cracks on the bodywork. The carbon aeroscreen has a few problems like a large air bubble in the top left hand corner and the carbon weave hasnt gotten into the front edge of the mold so there is a large amount of resin there, so I will be cutting the air bubble out and profiling the side to match, and then surround it all in edge trim and then give it all a polish and hopefully it should look quite good.

Another mate of mine has had experience with carbon fibre/fibre glass so he is going to give me a hand with the bodywork and I will post lots of pictures of the wrapping process in case anyone is interested in doing it.

Finally I've ordered of custom Roadster grills from this thread which I think will make the car look really nice:

http://www.haynes.co.uk/forums/showthread.php?t=8105

Any questions just give me a shout.
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9

My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020

Total Spent so far: Stopped counting
Reply With Quote