View Single Post
Old 4th October 2010, 09:11 PM
twinturbo's Avatar
twinturbo twinturbo is offline
Super Moderator
Join Date: Jul 2008
Location: Carlisle
Posts: 4,340


Drivers bulkhead lined up and a few welds put in, need to clean up a bit more before finishing the welds. Will try and get that done tomorrow.

I checked that the pedal box had a chance of fitting and it was spot on just need to drill the hole for the master cylinder. and the mounting holes.

Last on tonight's list was getting the rear tub panel into place, it had previously been trial fitted, but now with the ally tunnel and Deamon Gunge it would not fit, so a little metal was removed to get it to slide in.

You only get a woosh with a dump valve

Build Thread

Man Cave Mantiques

Cecil Street Auto Repairs Garage Carlisle

Build Cost 4181.65 - Last - Wheel Cylinders
Reply With Quote