Thread: Steveh1's build
View Single Post
  #45  
Old 7th November 2015, 10:52 PM
SteveH1 SteveH1 is offline
Senior Member
 
Join Date: Jun 2015
Location: Dublin Ireland
Posts: 291
Default

So i was given this roll bar its a standard caterham 7 bar

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

So my plan is to cut off the original mountings on the thick bar and put a flat bar plate on each end.
Then make a plate the same as cp3 and cp4 and mount them 50mm higher straight above cp3 and cp4 with nuts welded on the inside
Like build a box if this makes sense 50mm high

can anyone see a problem with this

Can i then weld 50mm box section between these boxes with the seat belt anchorage's welded into this bar
__________________
Slowly tipping over the edge into madness
Reply With Quote