Thread: Steveh1's build
View Single Post
  #46  
Old 15th November 2015, 10:23 PM
SteveH1 SteveH1 is offline
Senior Member
 
Join Date: Jun 2015
Location: Dublin Ireland
Posts: 291
Default

Ok so im not sure what to do about the roll bar

so i started making some of the chassis plates and despite what people were saying about just buying them laser cut i actually found the fabrication of these plates very rewarding and satisfying maybe its because there is a bit more work involved or maybe its because i saved money who knows.

so i got these drill bits a while ago its amazing the difference a good drill bit makes

Untitled by stephen harborne, on Flickr

i also got these during this week

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

m18x2.5 bar
__________________
Slowly tipping over the edge into madness
Reply With Quote