Thread
:
Rosco's haynes Build
View Single Post
#
46
15th December 2014, 08:00 AM
Rosco
Senior Member
Join Date: Sep 2014
Posts: 493
I don't no why but I have the latest book with the new 10mm longer wishbones but the jig drawings look like they haven't been changed, so I had made my jigs to that, then when I had made a wishbone and checked the bush centres they were 10mm short, to say I was unhappy was an understatement, I can't believe there's nothing on the amendments page just to give you a heads up, I think i will get away with it as I have wound my rod ends out 5mm and I might skim 5mm off the matting face on the stub axle or put a spacer behind the hub, so a std driveshaft fits
The rod ends are still in the tube insert a full 1" and they are only threaded that much so that's ok, just didn't really want them wound out to far
Rosco
View Public Profile
Send a private message to Rosco
Find all posts by Rosco