Very wise David .... I am afraid it would just fall on to deaf ears !!??
Once you have sorted the wheat from the chaff, there is some good information in that thead.
From my own point of view, that of your average joe " Home builder "
I am not in the slightest bit interested in the science or mathematics of any given material.
Dare say, if I was so inclined .... I too could trawl the net & find some maths or theory , copy this infomation & post it in a thread to make me look smarter than you average bear.
The failure of the camber adjuster on Ash's car interests me greatly .... It proves that this particular component has the potential to fail .... The most disturbing aspect of all this is the fact that things could have ended with a devestating fatality
Not too convinced by the supposed stress test .... Heath Robbinson to say the least, just about the least scientific test I have ever seen .... If not tested to destruction & accurate measurements taken, any such test is meaningless !!??
In light of recent events, I have decided to abandon the use of the quick adjusters .... Also concerned that mine were bought about the same as the one that failed & at this stage, a faulty batch cannot be ruled out !!
Thumbs up for Ash's revised wishbone boss with built in failsafe .... Alas I do not have the tooling to make these but would be interested in buying them if they became commercially available
Well that's my little rant over .... Safe motoring guys