Hi Enoch
It's a lot easier to drop the whole lot in one go, then remove the entire remote selector once the gearbox is not tucked up in the transmission tunnel.
To remove the remote selector assembly:
1/ Undo the 2 bolts, one on each side of the gearbox
2/ At the rear of the gearbox prise off the spring clip which holds the selector to the gearbox
3/ Slide out the pin that holds the actuator to the gearbox shaft - it should be easy as it's likely to have been well lubricated with gearbox oil.
4/ Lift the remote assembly off the gearbox.
I can post pictures if it helps - I'm currently trying to work out the best position for the gearbox mounts so it is all to hand.
Matt
|