the drilling out the centre of the 19mm stainless iv never done anything like that before
ive made pens out of very hard acrylic before have to get them down to half a mm thick too! so the bushes shouldnt be a problem
Andy
Quote:
Originally Posted by londonsean69
Which bit of that was technical
Oilon is basically an oil (lubricant) impregnated nylon.
It is well used for bearings, but not necessarily bushes, which also have to absorb shocks.
A few on here are using 'rigid' plastics for their bushes. I have to admit to buying a set of PU bushes complete with tubes when my lathe was up the spout.
Nothing to do with the horrible stringy mess turning nylon seemed to make
|