Thread
:
Steveh1's build
View Single Post
#
47
15th November 2015, 10:38 PM
SteveH1
Senior Member
Join Date: Jun 2015
Location: Dublin Ireland
Posts: 291
So not sure what to do About the roll bar so when making cp3 and cp4 i cut the roll bar end plates and drilled them on top of each other so they are an exact match
Untitled
by
stephen harborne
, on Flickr
both plates drilled
Untitled
by
stephen harborne
, on Flickr
both plates nuts welded
Untitled
by
stephen harborne
, on Flickr
__________________
Slowly tipping over the edge into madness
SteveH1
View Public Profile
Send a private message to SteveH1
Find all posts by SteveH1