View Single Post
Old 26th October 2014, 07:16 PM
Rosco Rosco is offline
Senior Member
Join Date: Sep 2014
Posts: 493

Got my roll bar bent up yesterday by Tom at, not to far from my house, bent out of 2" cds tube, well pleased with it,
I'm aiming to meet msa spec but not sure if the rear stays can be angled out, I'm going for a full cage but just got the rear hoop until I get my
Scuttle mounted and see what room I've got

It's only clamped on for now as I've got to finish drawing up my parts for laser cutting this week hopefully

And that's about where I'm up to

Thanks for looking
Reply With Quote