View Single Post
Old 30th November 2009, 10:23 PM
gingea1pom's Avatar
gingea1pom gingea1pom is offline
Senior Member
Join Date: Sep 2009
Location: wiltshire
Posts: 826

Actually cracked on a little this afternoon, I cut RS11 and 12 from 19 x 19 tube then realised they should be cut from 25 x 25 tube so took a breath and cut them from the correct size tube, and to my amassment they have another compound cut on one end, I am getting quite good at them now. Fully welded the suspension frame to CP1 and 2 as I flipped the chassis over to weld the underside of RS11 and 12.

The garage needs a good tidy up then I can start to construct CP3 and 4 on the weld table. I need to get a stock of nuts and bolts, I was thinking M8, 10 and 12 in full nut, Nylock nut complete with bolts in varying lengths, any top tips would be helpful.
Sent from my iPad, from who knows where in the world

I was building but I am not now!

Build Pictures

Build Thread
Reply With Quote