Geeman,
yes you are doing well, but lets get this front end sorted.
it may not be as easy as you say to just cut the bottom of FF2 & FF3 as where the bend in these two pieces is positioned it is critical to where you place the front upper suspension brackets, do me a favour please & go & get the measurement from the build table to the point of the bend in the FF2 FF3 at the outer most position, as this will determine the position of the suspension brackets mounting( i know you haven,t even thought that far ahead but it needs to be correct from where you are up to at the moment) hope i,m not being a pain in the butt?
andy