There are some things not explicitly said in the book I would like more details about :
- CP9 : around the cut for RP3, there is a "thin" edge (5mm) and a "wide" edge (15mm). Which one is supposed to come on the inside of RP3, which one on the outside ?
- CP25 : do I need 4 plates on each side of both CP9, or just 2 of them ? In that case (2 plates), are they supposed to be placed on the inside or on the outside of CP9 ?
My guess is the "thin" edge of CP9 on the outside of RP3, so CP25 can come under, as I have checked a thread http://www.haynes.co.uk/forums/showt...highlight=CP25
where it is said that it is only 2 x CP25, to be placed on the outside of both RP3, but I'd like to be sure.
Thanks in advance for your help.