View Single Post
Old 6th May 2011, 01:18 PM
MikeB MikeB is offline
Senior Member
Join Date: Apr 2007
Location: Nr Wellingborough
Posts: 512

Did some more welding on the chassis including tacking the the steering rack frame mounts on. I'm sure there is a dimension wrong in the book for the steering rack mount spacing

Got bored with welding so made some interior panels out of the ally I had knocking around the garage, it will be more difficult to cut once the build table has gone so a good job out of the way just need to order a new peice for the floor and bulkhead. I used a jig saw with a ali blade in it (I think wood blades work ok to) this seems to give a nice neat cut and a lot better than the angry grinder or aviation sheers.

I found this picture of my old chassis just after I sold it, a lesson to all if you have to sell up keep your chassis somewhere for the amount of cash you get for it you might want to build again. The good news is I'm nearlly back to where I was!
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here:

Last edited by MikeB : 6th May 2011 at 01:34 PM.
Reply With Quote