View Single Post
Old 14th October 2011, 10:52 AM
MikeB MikeB is offline
Senior Member
Join Date: Apr 2007
Location: Nr Wellingborough
Posts: 512

I had a go a wiring up a simple ignition circuit for my CVH just using the EDIS module and coil pack

IMAG0307 by mjb22001, on Flickr

edis4 by mjb22001, on Flickr

I did get a spark when cranking the engine over but it seemed a little weak.
So i wondered if I had it wired correctly.
The black wire is the positive feed to the coil pack and edis.
I didnt' have the 25uf suppression to ground fitted as I dont' have whatever a 25uf looks like
Also I wasn't 100% sure on the terminals 1 and 3 on the coil pack

The leads and plugs are fairly old also.
Any thoughts
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here:
Reply With Quote