View Single Post
  #2  
Old 31st October 2011, 01:59 PM
ozzy1's Avatar
ozzy1 ozzy1 is offline
Senior Member
 
Join Date: Jul 2009
Location: perth,australia
Posts: 760
Default

7" sierra diff have both bolt on and push in drive shafts.
Will the Wilwood calipers not bolt straight onto the standard sierra rear disk carriers?If they are designated M16 i think it is they will bolt straight on.
If the carrier bracket is supplied then yes it will be the drum brake carrier/hub.
As far as i am aware you can mix and match the ends of the driveshafts to suit diff/hub etc.
Im lead to believe that on the bolt in driveshafts on the diff this is just a flange held on by an internal circlip and can be removed to make the diff the push in type or you can fit the flanges to another diff to make it the bolt on type.
Personally i wouldnt modify the bearing carrier/hub i would get a new one machined up to suit.
Reply With Quote