St170 fuel injection on a budget project.
I thought I would start a thread on getting an St170 engine to run in a kitcar using its own ecu.
Yes I know you can stick bike carbs on it ect but you wont do it as cheap as this and get the same level of emissions imho.
Budget so far £45 BUT I DONT HAVE THE ENGINE YET
1hr's Work. Can I turn the immobilizer (Pat's) on and off.....Answer YES
http://youtu.be/4UMyy6HXvQ4
A good start but lots and lots of work to do.
I am also on the scroundge
for any st170 engine sensors that you guys havnt used on the bike carb or megasquirt convertions.
I am looking for
fuel rail pressure switches
Inlet manifold runner controle modual ( even faulty )
Maf
knock sensor
ect
If I get some donations to keep the project cost low I may even do a Full "how to"