Thread: Steveh1's build
View Single Post
  #214  
Old 18th September 2018, 11:25 AM
SteveH1 SteveH1 is offline
Senior Member
 
Join Date: Jun 2015
Location: Dublin Ireland
Posts: 291
Default

So ive got a bit done recently
First i built an spacer for the new rear coolant pipe for the reroute to move it out from the block

Untitled by stephen harborne, on Flickr

Then i filled in the the hole in the side coolant connector

Untitled by stephen harborne, on Flickr

Used a 20 cent to stop the epoxy running into it

Untitled by stephen harborne, on Flickr

Filled with epoxy

Untitled by stephen harborne, on Flickr

The hole was a feed for the interior heater so is not needed
__________________
Slowly tipping over the edge into madness
Reply With Quote