View Single Post
  #22  
Old 8th April 2010, 01:21 PM
spud69's Avatar
spud69 spud69 is offline
Senior Member
 
Join Date: Jul 2008
Location: Hartlepool
Posts: 1,678
Default

Quote:
Originally Posted by jasongray5 View Post
Apparently if you do need to get it apart, then you just need to slide a razor blade between the 2 surfaces, a right bitch to do so im informed tho...?
You can get the extending craft knifes from B&Q or much cheaper at a local pound shop where the blade extends about 4", usually snaps off every 1/2" to give a new sharp edge, but these make it much easier to split the seal.

Could just use 4mm bolts with washers and butterfly nuts and get some nice edge trim from cbs:

http://www.cbsonline.co.uk/rubber-p-...pi2-3527-p.asp

works a treat and finishes it off nice.

AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com

Regards..........AndyH
Reply With Quote