no problem
yep petrol works aswell
for the pistons im not too sure but i would say again some sort of cleaner and an old tooth brush
if you are replacing the rings for the groves some fine sandpaper (1000 grit) folded over would be your best bet.
the oil that should be put in the engine is '5w 30 fully synthetic' according to a website but im not too sure probably best to check elsewhere and be sure. I would probably use the same oil the engine takes when putting it back together but any oil is better than no oil
not sure about the valves but somthing like the above should work. the valve stems themselves should just be clean i would avoid sandpaper here.
when you put the main and big end bearings back in only oil the crankshaft face... the other face on the cap needs to be as tight a fit as possible to the bearing
Jake
Last edited by car.mad : 18th October 2009 at 08:34 PM.
|