Front and rear toe can be got pretty dam close by making yourself a string computer
Get 2 lengths of wood the width of an inch or 2 wider than the car clamp them together and drill a hole in either end then take 2 equal lengths of string about 6 inch longer than the car and feed them into the holes and tie
Now using tone stands the same hight as the wheel centres to support the wood so the string is either side of the car measure from the string to the wheel centre making sure its square on all corners (this may take a while) then you can set the toe by measureing the front of each wheel
Its a bit long winded but its basically what they do in garages only the do it with lasers these days
|