View Single Post
  #1  
Old 31st December 2009, 05:57 PM
Enoch Enoch is offline
Senior Member
 
Join Date: Nov 2009
Location: Near Boston, Lincolnshire
Posts: 788
Question Rear lower wishbone design

Hi folks, I have just about finished cutting the parts to make the wishbones but am not happy with the diagonal braces on the rear lower. My issue is that as it is cut at such a sharp angle, when it is filed to fit the part where it is welded is very thin. I was considering replacing the diagonal with either 1 or two braces that go straight across between the two 2 "arms". I can't see any reason why this would not work, I think they would be easier to weld as they would not be close to the suspension bush tubes, as they are in the original design. Anybody got any thoughts on the matter?
Enoch.
Reply With Quote