View Single Post
Old 17th November 2012, 05:38 PM
Eddy Eddy is offline
Join Date: Jun 2009
Posts: 89

Few bits arrived from Phil during the week - He is sending bits through as they're ready:

Got a coat of anti rust primer on the drums:

Followed by the first top coat:

Then I started looking at the manifold I need to make for the bike carbs:

Not sure if I should re-space the carbs or just go with tubes at an angle - Any opinions?

The tubes in the pic are from some scrap I had lying around - They match the ID of the carb outlet perfectly, but are thin so there is a bit of a gap between the silicone tube. Will this be ok (or even helpful in getting the angles to work) or do I need some thicker tube?


Last edited by Eddy : 14th July 2013 at 12:31 PM. Reason: Photo links changed
Reply With Quote