One guy from work has lathe, I draw some sketches and he did for me some parts:
Crush tubes, bush tubes... with DIY polyurethan bushes (I made them myself from two-component polyurethan resin)
It's just an example - I got whole set of them...
Front camber adjusters, sleeve tubes and rear camber tubes (?):
DIY sprocket adapter almost ready (SAE1140 flange)...
Need some welding...
... and then turning/balancing...
Tomorrow I plan to weld it but balancing/turning have to wait until water cooled lathe defrost and start to work again...
Next week I will have catalytic gas heater - maybe this would help keep me warm while building.