Today saw a little further progress.
We drilled the holes for the passenger tunnel panel, and a few guide holes for the rear seat back.
The holes for the seat mounts on one side were drilled. ( note that in no way was there an error in the location of the rear mount, it was a fully intentional move to take the extra weight
)
We then rotated the chassis to the horizontal and checked to see if my seat mounts were going to fit the seats.
Progress was then slow as the chassis became infested with...
Three hours later, the chassis was back up on it's side, the tunner rails ( PSGR ) cleaned up and after applying gooop that was stickier than sticky stuff in sticky land. The panel was rivited in place..
Unfortunately the battery was flat on the camera by now.
TT