[Davidbolam]

Originally Posted by CTWV50

Makes me scared to touch them. I can be a bit clumsy at times. David have you thought about how best to fit the side panels? Don't know whether to use silkaflex polyurethane stuff and minimal rivets or just loads of rivets? I'd like to be able to take them off if need be without damaging them.

They are looking good! I put mine along the chassis last night. I'm going to have to do a little bit of fettling and maybe put some counter sunk rivets in my floor for them to fit easily. Was planning on using rivets so I can remove them as well.

I made sure I made a load of templates for anything needing to be carpeted / covered as figure it will be a righ pita once they are on.

I'm a bit terrified to touch them myself and have enforced a "no go zone" anywhere in the garage.

Alan cut out my front panel as well for me. I've never seen someone get so dusty (without a masky before.

I will try and keep taking photos when I put them on

David