![]() |
#1
|
|||
|
|||
![]() Hi Folks, just updated me build diary again. I now have the diff and rear suspension done as well as most of the front suspension. I have also done the floor and pedal box but not written the pedal box bit up yet. www.deepfolly.co.uk
Best and all that, Enoch. |
#2
|
||||
|
||||
![]() Like the nut covers!!! could sell some of them if it's cost efective
![]() TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#3
|
||||
|
||||
![]() Another cracking read is that Enoch
![]() Pleased to read of no major dramas during that stage of the build ![]() After the hairy moment you had last time you removed the engine, I can understand your reluctance to start playing with that job !! I do like what you have done in the nut cover department .... Adds a nice professional touch and is very pleasing to the eye ![]() Well done, you have made remarkable progress. ![]()
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie ![]() www.roadster-builders.co.uk |
#4
|
|||
|
|||
![]() Thank you, gentlemen. I think I will seek assistance when I come to do the engine, just to avoid mishaps. Last time it wasn't too bad but a similar incident with much more weight on the car and less room to get out of the way could represent a sub optimal scenario
![]() I think the track rod covers have come out quite well, my intention is to make another pair slightly larger to go over the actual rod end. I think when they are done they will look good, making it very hard for the man at del Monte to say "no" ![]() I will offer the design to the blokes at Saturn so they could make and sell them if they wanted to. I have no desire to do them myself as I would not have the time. If someone can make a few bob out of them and eliminate a headache for builders then I shall be a happy man. Best and all that, Enoch. |
![]() |
Thread Tools | |
Display Modes | |
|
|