|
|
#1
7th August 2011, 06:41 PM
|
|||
|
|||
Question ....
Hello was wondering if anyone had a measurement between the rear of sb2 and saturn's grp rear tub, just trying to check that my fabricated fuel tank will fit, many thanks in advance.
Richard
__________________
Richard Just keep going we will get there in the end. 
|
|
#2
8th August 2011, 11:12 AM
|
||||
|
||||
Hi Richard,
I have attached a pdf showing the dims of the rear end and also for a fuel tank size to fit. The distance from SB2 to the rear of the top of the panel is 400mm. Hope that helps....Andrew
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#3
8th August 2011, 12:19 PM
|
||||
|
||||
|
Blimey Spud those drawings have been around a while. Didn't realise anybody had downloaded and saved them.
Proof I have my uses whatever the wife says, lol.
__________________
http://s831.photobucket.com/user/dav...ter%20Pictures OTR 01/05/14 - 1.6 CVH, Type 9, Bike Carbs, Megajolt
|
|
#4
8th August 2011, 12:33 PM
|
||||
|
||||
|
Quote:
Andrew
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#5
8th August 2011, 08:32 PM
|
|||
|
|||
|
Thats fantastic thankyou spud, helps a lot
__________________
Richard Just keep going we will get there in the end.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
