|
#1
|
|||
|
|||
Clutch slave cylinder extension
I have positioned the T50 gearbox where I want/need it to be but I have a problem the clutch slave cylinder is very very close to U7
[IMG][/IMG] [IMG][/IMG] What I was thinking id could I make a bracket to move the clutch slave cylender back and extend the clutch slave cylinder rod by the same amount which would give me clearence with U7. Yes I will be replacing the slave cylinder. also I will cut the end of the fork to clear the chasis plate. or would it be better to move or modify U7 ?
__________________
My build diary is at http://thailoz.wordpress.com/ Last edited by thailoz : 3rd March 2014 at 11:06 PM. |
#2
|
|||
|
|||
Make a bracket and move cylinder forward and fab a longer rod ?
Or mod U7.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. |
#3
|
|||
|
|||
yep which would be better?
__________________
My build diary is at http://thailoz.wordpress.com/ |
#4
|
|||
|
|||
What ever is the least hassle,maybe cut the upright and dogleg it out of the way.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. |
Thread Tools | |
Display Modes | |
|
|