![]() |
|
#1
|
|||
|
|||
![]() Hello guys, Just a quick one to let you know I have started my build today. I collected my completed MX5 based chassis and wishbone pack from Saturn today and I am really pleased with it. A couple of hours spent in the garage using the vice to push the suspension bushes in and i am well under way!!. I have already gathered together a selection of mx5 bits over the last few months whilst I was waiting for the MX5 variant to be launched. I will initially put in a 1.6 engine and have a limited slip diff as well.
I have tried to upload some pictures but I keep getting an error message saying the file size is too big! Once I have worked this out I will post the images. David |
#2
|
||||
|
||||
![]() Good luck
![]() and have fun. Upload the photos to something like photobucket, you can then link to them rather than uploading them to the forum. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#3
|
||||
|
||||
![]() Good luck with your build David, you,ll soon have it at the rolling stage & sitting in it going "brum brum"
![]() keep us posted on your progress ![]() cheers andy |
#4
|
|||
|
|||
![]() Ahh...so it was your chassis I was poking* about when I was up at Saturn last weekend
![]() If you're collecting bits off different MX5s, make sure that the driveshafts and prop match your diff - they're different between the 1.6s and the 1.8s. *Oi you - at the back there! Stop sniggering! ![]() |
#5
|
|||
|
|||
![]() Thanks for the motivating messages. I have been getting all my mx5 parts from 1 source. Its a company that race mx5's so they have been giving me a few tips for further down the line!
|
#6
|
||||
|
||||
![]() You may have to share that source of parts with me lol
|
#7
|
||||
|
||||
![]() Usually fuel lines are listed by the size of the bore not the od.
|
![]() |
Thread Tools | |
Display Modes | |
|
|