|
#1
|
|||
|
|||
Fabricated Scuttle
Hi
Interested to know if anyone has fabricated the scuttle as shown in the book Cheers Dave F |
#2
|
||||
|
||||
I had 3 attempts....
Anybody want to buy some scrap alloy? David |
#3
|
|||
|
|||
I am intending to make one, but I can't seem to find a dimension for the height
__________________
Sean |
#4
|
|||
|
|||
Scuttle
I,m having same trouble in finding the scuttle height. I was hoping that some had already built one
Dave F |
#5
|
||||
|
||||
I have a 13 page document by Mark Allanson on fabricating a scuttle.
__________________
Regards (The mad Sarf Efriken) |
#6
|
||||
|
||||
Funily enough, so do I
|
#7
|
|||
|
|||
I would hope that some one will pop outside and measure there's. If your engion and rad are in it canot be that hard to work out a sutable scuttle hight. Shore it canot be to critical. Aslong as you can see over it and the bonet still clears the engion.
|
#8
|
|||
|
|||
Make it whatever height you want as long as you can see over it...
I made the fibreglass ones approx 10" if that helps? Biggest problem is engine clearance as you need a straight run down to the nosecone or the car will look odd. |
Thread Tools | |
Display Modes | |
|
|